Cardboard Box Manufacturing Machine SFC1700 Automatic Corrugated
Carton Box Flute Laminator Machine
1. Performance characteristics
1. This machine can laminate combination of two corrugated boards
and any type of top sheet together. It can produce two -layer board
(cardboard + cardboard), 3ply, 4ply, 5ply, 7ply and other products.
2. Laminating type: corrugated + corrugated + cardboard, corrugated
+ corrugated, corrugated + cardboard, cardboard + cardboard,
cardboard + gray board + cardboard, etc.
3. Automatic detection of top and bottom paper, automatic servo
correction technology. Make the top paper automatically track and
fit the bottom paper, and the accuracy is high.
4. The bottom paper feeding partuse imported servo motor
controlling system, with Japan NITTA suction belt and together with
lead edge feeding system.
5. The multifunctional rack of the bottom paper are suitable for
curved corrugated.
6. Large stainless steel glue roller (160mm) with fine anilox
grinding to guarantee even glue coating even at min glue quantity.
7. The dual -use lifting platform, we can use the pre-stacker
structure to push the pre -pile of paper into the platform. We can
also push the stack of paper directly into the platform.
8. Special polyethylene materials on the surface of the coating
roller and pressure roller, glue is automatically dropped off, free
scrubbing.
9. Use a circulating glue system to reduce glue loss and stabilize
glue adhesion effect.
10. One -click adjustment of the whole machine (just enter the
paper size).
11. Video monitoring.
2. Parameters:
| Model | SFC1500 | SFC1700 | SFC1900 | SFC2200 |
| Max size | 1500*1500mm | 1700*1700mm | 1900*1900mm | 2200*2200mm |
| Min size | 360*380mm | 360*400mm | 500*500mm | 500*500mm |
| Top sheet thickness | 120-800g/㎡ |
| Bottom sheet thickness | ≤10mm |
| Work speed | 160m/min |
| Power | 22kw | 22kw | 24kw | 24kw |
| Stick accuracy | ±0.8mm |
3. BRANCH INTRODUCTION:
1. BOTTOM PAPER FEEDING
The two bottom feeding part adopts lead edge feeding, the wheels
use unidirectional bearing (reduce the wear of rubber wheels). The
wide rubber wheels ensure that the E, F, and G corrugated does not
deform.
Two sets lead edge feeding system, suction is greater, the
stability is higher, and the cost of use is lower.
2. ELECTRICAL SYSTEM
Mainly using Siemens electric system to ensure machine stability,
high efficiency and low failure. Using man-machine interface and
PLC combination, display all the information on the screen.
Machine has 7-9 servo motors, use Siemens PLC and frequency
inverter.
Mainly use SKF and NSK bearings.
3. TRANSMISSION
Equipped with sensors and servo motor, control top sheets to do
independent compensation action to make sure high accuracy. The
design of large stainless steel anilox roller (160mm in diameter)
is stable and high-efficiency, coat evenly and save glue volume.
Use a circulating glue system to reduce glue loss and stabilize
glue adhesion effect.
7. ANILOX ROLLER & PRESSURE ROLLER
Anilox roller diameter is 160mm, In the case of high -speed
running, the roller speed is still very slow and does not shake the
glue.
Pressure roller diameter is 150mm, Special materials on the
surface, do not stick glue, free to clean.
